a) do the calibration of BI-Direction b) set the optimal height of the head c) clear the encoder with a dry cloth dust-free-gently so as not to damage the

a) lower the head b) set the highest resolution c) select the print mode from the unilateral imposition of d) release the carriage speed

a) replace the cable leaks, remove the filters) between the ink tanks and head. b) replace the wiper of the head c) set the printing function of the COLOR BAR d) to check the status of the consumption of the plotter head-head over time loses its parameters and comes to a similar phenomenon.

a) do the 2 strong head cleaning b) complete the ink level in the tanks, always leave the ink at the same level for all colors-you can avoid in the future similar disturbances.

a) run PHOTOPRINT and calibrate media feed b) select another profile c) check the quality of the media do the same print on another ground d) check the ink level in the tanks and fill in the gaps e) make sure that wężykach to the head are visible air bubbles f) observe whether you print

a) check for leaks between head and captopem, the head must tightly adhere to captopa. b) if captop is attached tightly to clean the print head does not help, replace the captop or follow the steps indicated below. a) follow the procedure cap clean video. b) make sure that the drainage tubes are way-fluid and

a) take a test head, make sure that all jets are way b) do the head cleaning and retake the test d) if there has been improvement, but still paskuje follow the cleaning procedure to effect c) if the head is the way start printing

a) clear the sensor using a cloth or algae cleaner (without fluid) b) verify that the sensor is properly connected c) make sure that the sensor is not broken or detached for carriage of d) does not help, make a service request.

a) check whether the key "dongle" is connected to the computer USB. b) make sure that the connected key lights up green if it does not pass to another USB port. In the absence of a response install the drivers key. c) disable antivirus and firewall programs. d) restore Windows to previous configuration-manual. e) install

a) restart the computer and plotter. b) check whether the driver is installed correctly-Windows device manager. c) replace the USB cable d) does not help-make a service request.